K40,K42, K44 Carbide Standard Gear Hob with Topping or Non-Topping
2023-05-03 09:56:58
jiangxingTools
2122
K40,K42, K44 Carbide Standard Gear Hob with Topping or Non-Topping
Grade K40, K42, K44 carbide hobs are mostly used for large production, must be recoated after being resharpened.
Carbide gear hobs are offered with tooth profile DIN 3972 standard Non-Topping or Topping
module rangle for carbide hobs are M0.1-M5, OD Φ16-95, Length 8mm-180mm,bore Φ8-Φ40mm
carbide hobs for finishing cut, pre-grinding, pre-shaving, modified, chamfering, spline shaft, timing pulley, rectangular spline,triangular spline, worm/ratchet,etc special profile.
相關(guān)文章
-
Taper Shank Type Shaper Cutters with DIN 1828
Taper Shank Type Shaper Cutters with DIN 1828These shaper cutters are 20° PA, non-topping finishing... - GB Standard Gear Shaving Cutters with M2~M8
- PA20° Standard Involute Gear Milling Cutter with Module m6
- Bohler S290 Microclean
- PA20° PCD 160mm Disk Type Gear Shaper Cutter with Module m6~m10
- Solid Carbide Small Module Cycloidal Gear Hob
- Timing Pulley Hob for S.T.D L(9.525)
